OK No Change faulty item(s).
The autopilot may be calibrated t to suit a particular vessel.Spacer (early units only).D296, sT3000 Autopilot, z155, ST3000 Autopilot, service autohelm Manual.Store the selected setting by pressing the -1 and Standby keys for 10 seconds, when the control autohelm autohelm head returns to normal operation.Press the Standby key until manual the display shows P followed by a number.This sequence manual continues until either the Standby or Auto key is pressed or the unit manual is powered down.Manuals and User Guides for Raymarine Autohelm ST3000.In this condition the user cannot change any settings.Facia (Note A).Click here manual FOR ALL manual manuals). Before Dismantling, before dismantling the autohelm ST3000 check the phase of the autopilot cheat (If.
Fluxgate ground yearbook Display bezel (4) (x2) 11 (x2) PCB (9) Wedge (27) Insert wedge (27) as shown to secure display bezel leg 27 (x4) raymarine Early units Later units (x4) Note B Important: The fluxgate loom in some early units is wired differently.
New (other lowest price.99, free Shipping, get it by Tue, Aug 20 - Wed, Sep 11 from Houston, Texas.
Raytheon Pathfinder SL72 /SL74 Radars.
Shield (screen - black sleeve).
SportPilot and raymarine SportPilot Plus Service Manual 83056-1 autohelm.
Comments ST3000 drive module Q45 Complete drive 1 2 3 4 ST3000Gearbox/Drive assembly, including Pin Clutch flange Gearbox housing Seal 2,1 manual Clutch flange pin H006 7 Motor Q101 10 Pod H001 Q102 Also part of Q102 Motor replacement If the gearbox is noisy when the.
PCB condition allows) by driving the pilot, in standby mode, with the course change keys.No OK OK No Change motor.Any attempt to linearise the compass or enter calibration when the lockout function is enabled will result in the display showing Cal Off.P 0 6 indicates Version 6 software Calibration lockout To stop access to compass linearisation and calibration functions on the ST3000 autopilot:.Autopilot type selection The Autohelm range of cockpit pilots all contain the same software but each codes pilot runs a different program.Toggle between CAL ON and CAL OFF using the -1 and 1 keys.Restore password, upload manual upload from disk upload from url.If the spares blade PCB contains software of a higher issue than before then the relevant Operating Supplement must be supplied when the equipment is returned to the customer.